3
300
MM
PORTABLE VENTILATION
FAN
Fan Safety Instructions
1. This fan is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
fan by a person responsible for their safety.
2. Children should be supervised to ensure that they do not play with the Fan.
3. Carefully read all instructions before operating the ventilator for the first time and save for future reference.
4. This fan is intended for commercial & industrial use. Do not use this Fan for anything other than its intended use.
Misuse may cause injury.
5. The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using
electrical fans. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA.
6. To protect against electric shock, do no immerse the fan, cord or plug in water or any other liquid.
7. Disconnect the power plug before dismantling, assembling or before cleaning and when the fan is not in use.
8. Avoid touching the moving parts of the fan.
9. Ensure the fan is on a dry and even surface.
10. Never insert fingers, pencils or any other objects through the guards
11. The fan must have all guards assembled/fastened correctly, according to these instructions before use.
12. Do not operate in the presence of explosives and/or flammable fumes or liquids
13. Never leave the fan running unattended.
14. Never carry the fan by the cord or pull the cord to disconnect from an outlet; instead, grasp the plug
and pull to disconnect.
15. It is recommended to regularly inspect the fan. To avoid a hazard do not use the fan if power cord, power plug
or fan becomes damaged in any way. Return the fan to the nearest authorised Service Centre for examination and/or repair.
16. This blower contains inlet and discharge guards/grills designed for your safety. NEVER operate this blower without both
guards/grills in place. Should the guards/grills become defective, altered or missing, this blower should NOT be used until
the guards are replaced.
17. DO NOT use this unit to exhaust air from a confined space. This can cause death by asphyxiation.
18. DO NOT place or operate ANY exhauster/blower inside a tank or confined area that contains, or did contain, any volatile fumes,
gases or liquids. A fire and/or explosion can still occur. DO NOT locate this blower in a corrosive atmosphere, nor where the
ambient temperature will exceed 104°F (40°C). DO NOT exhaust any air, gas or fumes which can exceed 150° F (66°C).
KP1003 ASSEMBLY INSTRUCTIONS
UNPACKING
Unpack all the components from the box.
When unpacking the ventilation fan, carefully inspect for any damage that may have occurred during transit. Check for
loose parts, missing parts or damaged parts.
Ensure all packaging material are disposed of as per your local council guide lines.
ASSEMBLY
The KP1003 Ventilation fan is shipped fully assembled.
INSTALLATION
Portable:
The KP1003 is equipped with a carry handle (4) for portability.
The ventilation fan also has 4 rubber stablizing feet (7) mounted under the support legs (6). These rubber stablizing feet (7) are to
help keep the unit stable and prevent movement from vibration.
Permanent:
If the ventilation fan will be mounted in a permanent location, the Ventilation fan can be installed with the motor in any
position, including vertical.
The rubber stablizing feet (7) should be removed before bolting the ventilation fan to the floor, wall, bench, dolly, etc.
Using a 14mm Spanner and 14mm Socket remove the bolt and nut fastening the rubber stablizing feet (7) to the support legs (6).
The ventilation fan should be bolted using 8mm bolts through the 4 holes in the support legs (6).
Note: Shims or rubber pads (not supplied) may be required to reduce vibration.
