4
STEEL FABRICATED OFFSET VICE
Maintenance
1.
Before each use, inspect the general condition of the vice. Check for misalignment or binding of moving parts, cracked
or broken parts and any other condition which may effect safe operation.
2.
Keep machined surfaces and all moving parts clean and free of dirt, chips, and foreign materials.
3.
Use multipurpose grease to keep moving parts lubricated.
4.
Routinely apply mineral oil to machined surfaces to prevent surface rust.
Office Contact Details
Phone:
1300 657 528
Fax:
1300 556 005
Email:
Website:
www.kincrome.com.au
Caring For The Environment
When a tool is no longer usable it should not be disposed of with household waste, but in an environmentally friendly
way. Please recycle where facilities exist. Check with your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw materials. Reuse of recycled material decreases pollution
in the environment. Please recycle packaging where facilities exist. Check with your local council authority
for recycling advice.
Notes:
Warranty
Warranty given by Kincrome Tools & Equipment Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria, Australia (Tel +61
3 9730 7100) If this product has materials or workmanship defects (other than defects caused by abnormal or non warranted use)
you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes addresses
for repair or replacement. Your rights under this warranty are in addition to any other rights you have under the Australian, United
Kingdom & Ireland Consumer Law or other applicable laws. Our goods come with
guarantees that cannot be excluded under the Australian, United Kingdom & Ireland Consumer Law. You are entitled to a replace-
ment or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
For further details please visit www.kincrome.com.au or call us. Due to minor changes in design or manufacture, the product you
purchase may sometimes differ from the one shown on the packaging.
