kincrome K13263, Manual

Page: 6 / 8

5
INDUSTRIAL 1/2” DRILL REVERSIBLE
Installing and removing the drill bits
WARNING! Disconnect tool from air supply before servicing or changing accessories.
To Install drill bits:
1. Remove the air supply from the reversible drill.
2. Insert the drill bit as far as possible into the the keyless chuck (6).
3. Once the drill bit has been placed inside the keyless chuck (6), turn the keyless chuck (6) clockwise to fasten your drill bit
secureley.
To remove the drill bits:
1. Remove the air supply from the reversible drill.
2. Grab the keyless chuck (6) firmly and turn anti-clockwise to loosen the drill bit out of the keyless chuck (6).
3. Remove the drill bit.
10) Cleaning, Maintenance, and Lubrication
Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular operation of the
air-operated tool.
The air motor and bearing uses compressed air to power the tool. Moisture in compressed air will rust the motor components, you
must lubricate the motor daily with Kincrome air tool oil.
Lubrication
1. Disconnect the tool from the air supply holding it so the air inlet (1) faces up.
2. Hold the trigger (4) down and put 4 to 5 drops of Kincrome air tool oil in the air inlet (1). Holding the trigger down helps circulate
oil in the motor.
3. Connect the tool to air supply, cover the exhaust (2) with a towel and run for a few seconds.
WARNING! Any excess oil in the motor is immediately expelled from the exhaust (2). Always direct the exhaust (2) away
from people or objects.
Storage
1. Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool and run it for a short time.
2. Regular inspection should be carried out of the keyless chuck (6) and accessories for wear.
11) Warranty
Warranty given by Kincrome Australia Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria (Tel 1300 657 528). The applicable
warranty period (24 months) commences on the date that the product is purchased. If this product has materials or workmanship defects
(other than defects caused by abnormal or non warranted use) you can, at your cost, send the product to place of purchase, an autho-
rised Kincrome service agent or one of Kincromes addresses for repair or replacement. Your rights under this warranty are in addition to
any other rights you have under the Australian Consumer Law or other applicable laws. Our goods come with guarantees that cannot be
excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any
other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of ac -
ceptable quality and the failure does not amount to a major failure. For further details please visit www.kincrome.com.au or call us. Due
to minor changes in design or manufacture, the product you purchase may sometimes differ from the one shown on the packaging.
IMPORTANT! If the tool fails to operate correctly, call customer service on 1800 657 528 for advice on the best resolution for your situa -
tion. If a resolution cannot be achieved over the phone please take the tool and all related accessories to an authorised service centre or
place of purchase showing proof of purchase for assistance.