3
ENGINE LEVELLER 680KG
IMPORTANT SAFETY INFORMATION
WARNING!
Dynamic Loads, (load which swings, slips from centre or moves quickly)
can exert a force much greater than their physical mass (weight) resulting in failure
of the Leveller and/or loss of the load leading to property damage, personnel injury
or even death.
a. The use of an engine Leveller has inherent dangers to avoid risk of personal injury or property damage make
sure you are fully aware of the operating instructions for this product and any recommendations in the vehicle
owners manual prior to using this tool.
b. Do not exceed maximum lifting capacity of this engine leveller.
c. This engine Leveller is intended for automotive and small engine use only.
d. Be aware that large or heavy engines may exceed the stated capacity check vehicle owners manual or contact
the engine manufacturer.
e. Do not use for any other purpose except the supporting of an engine on a suitable lifting device.
f. The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator that common sense and cautions are factors
which cannot be built into this product, but must be supplied by the operator.
UNPACKING AND ASSEMBLING STAND
UNPACKING CARTON
Place carton in a clear, open area such as garage floor. Remove components and lay them out neatly on selected
work surface. Make sure all nuts, bolts, washers, and pins, are properly assembled, Keep L brackets
safely stored until needed.
ASSEMBLY INSTRUCTIONS
CAUTION
:
Supporting an engine using an engine Leveller can be dangerous. This engine
Leveller is designed and intended for use by properly trained and experienced personnel only.
If you are not familiar with the proper and safe operation of an engine leveller, do not use until
proper training and knowledge have been obtained.
1.
The Handle (8) needs to be positioned on the Engine Leveller before use.
To do this:
2.
Remove the screw holding the knob to the Handle (8).
3.
Place the Handle (8) outside of the Crank (9) and replace the screw.
