Kimo SL 100, User Manual, Page: 8 / 12

6.2 New measurement
After recording of results in his file, the operator can launch a new
measurement. Here are the actions :
1 . 1 x A message alerts the operator of a reset of
memory backup.
2. 1 x Memory is erasing , visualized by the progress
Memory is erased, the operator can launch a new measurement.
7 Operating information
7.1 Over-range
Although it is quite impossible , in very special conditions of reflections concentrated to the sensor, a
pictogram of exceeded range appears .
It comes for an irradiance higher to 1300 W/m2 . The maximum value will indicate 1301 W/m² .
7.2 Sensor default
In case of a defective sensor (sensor unplugged) during the measurement, symbols appear
and disappear after its proper connection.
During the dysfunction sequence:
The chronometer still running correctly, it indicates to the operator the real duration of measurement
containing the time of sensor default.
Max. min., M. irradiation values are false. Only the energetic exposure is exploitable on the duration of
running without sensor default detected by the instrument.
To remind the operator this default and to keep it into consideration in exploitation of results, a pictogram is at the top of the screen
for the measure. It is also displayed after the measurement.
7.3 Power source
When the instrument is equipped with alkaline batteries, it can operate for 72 hours minimum . A symbol informs the user about
electric power remaining. If battery is low, less than 1 bar on the pictogram, the instrument stops measuring, save current
measurement and switches off.
8
Over-range
Sensor default
* * *