3
034135 • 9/2019
7. Test the fit of the dispenser in the hole.
(Figure 8)
8. Determine if additional framing is
needed for the install. For jobs on 16
inch centers, additional framing will be
needed. Use 2 x 4” ‘s and 1 x 4” ‘s and
balance the framing on each side as
needed.
(Figure 9 & 10)
9. Measure the fit to the dispenser again
to ensure that the fit will be right. Shims
may be needed at this point.
(Figure 11)
10. Install dispenser using 4 screws in the
side of the housing attaching to the studs
in the wall. Before adding screws, check
to see that the unit is level. Add 2 screws
on the top side and two on the bottom
side of the housing. Do not overtighten.
(Figure 12 & 13)
11. Insert the module by lining it up with the
guides on the back housing and push
down gently to click the module in place.
For detailed instructions see the video
on installing the module and loading the
paper. The module is sold separately.
12. Add the operating label that comes with
the module to the inside of the door, then
install the door. The swing arm is taped
to the back housing, remove tape and
install the swing arm by using the black
plug that came with the dispenser into
the cover. This prevents the door from
sagging.
(Figure 14 & 15)
8
9
10
11
13
12
14
15
