Canopy
®
2
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent. If you have
any questions concerning these instructions, please call Kimball Customer Care.
Part 3033333, Revision A
Assembly Instructions
Figure I
8.
Check vertical alignment of canopy from right side. If can-
opy is leaning, loosen machine screws on correct side with
Phillips bit.
If canopy is leaning towards base, loosen set
screws. If canopy is leaning away from base, tighten set
screws.
When desired alignment is achieved, carefully
tighten machine screws back into threaded flat plate.
9.
Lay plywood platforms on static legs.
Note: radius edge
sets away from canopy as shown in Figure E top right
corner.
Push to back edge and center left to right between
plates. Attach using drill/Phillips bit and (48) #10 X
5/8”
wood screws up through the plate into platform.
See Figure
E.
10.
If cushion is attached, lay cushion on top of plywood plat-
form, center cushion on platform. Remove #10 X
5/8”
wood screws and attach cushion using drill/Phillips bit and
(4) #8 X
1
-
1/2”
flat head wood screws on both sides.
See
Figure F for location of screws
11.
Push end cap over L
-
support as shown in
Figure G.
12.
Plug up/down or programmable switch into ethernet port
and run cord to wire management groove cut in tube. At-
tach up/down switch to worksurface in next step with (2)
screws provided in base box with drill/Phillips bit in de-
sired location
13.
Lay rectangular and round worksurfaces in their respective
places centered left to right and using dimensions shown in
Figure I.
Attach using drill/Phillips bit and remaining
worksurface screws.
Note: rectangular worksurface
screws are packed with bench base, and wood screws
for round top are packed with H
-
frame.
12.
Using bubble level, place on top of plywood shelf on both
sides to check base is level to floor. If either side isn
’
t level,
adjust glides accordingly to help with alignment of base
and vertical alignment of canopy.
13.
See Figure J for completed base.
Figure E
Figure F
Figure G
Use (4) outside holes
for flat head #8 X
1.5”
wood screws
Figure H
Up/Down
Switch cord
groove
UP/DOWN
SWITCH
PORT
ACTUATOR
PORT 1
ACTUATOR
PORT 2
Figure J
6-1/16"
4-3/4"
