recommended by the manufacturer.
6. Never operate the furnishing in shower. NOT FOR IN-SHOWER USE.
8. Do not use outdoors.
9. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
11. This furnishing has an external power supply box (LED Driver) with rating of AC 100-135V, Output 15V, 660mA.
This furnishing's mounting base plate attaches to a single-gang electrical box size 4 H x 2-1/8 W x 1-7/8 to 2-1/16 D inches
12. Risk of Electric Shock. Connect this furnishing to a properly grounded branch circuit.
See grounding instructions below.
13. This furnishing is intended for commercial and residential use only.
CAUTION
Furnishing may get Hot. Keep away from curtains and other combustible materials.
- Do not touch hot lens, guard, or enclosure
Lamp gets HOT quickly!
- Contact only switch when turning on.
- Do not touch the lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
Lighted lamp may become HOT!
- Keep lamp away from materials that may burn.
- Turn off power and allow to cool before replacing lamp.
Do not operate the luminaire with a missing or damaged shield.
Consult a qualified electrician to ensure correct branch circuit conductor.
1. This furnishing does not use lubricants. Servicing is to be performed by an authorized service representative.
2. Use ONLY a soft damp cloth to wipe clean and dry. DO NOT use cleaners or other solutions as it will damage the finish
KIMBALL and YOUNG
Model: 945-xx-x5HW
Manufacturing Date:MMYY
Input AC120V, 50/60Hz, Output 15V, 0.1 A
SUITABLE FOR DRY AND DAMP LOCATIONS
For Commercial and Residential Use Only
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical furnishing, basic precautions should always be followed, including the following:
Read all instructions before using this furnishing.
7. Never drop or insert any object into any opening.
DANGER
- To reduce the risk of electric shock.
3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
5. Keep the electrical wires away from heated surfaces.
1. Always disconnect this furnishing from electrical power before maintenance.
1. Disconnect from grounded branch before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
WARNING
- To reduce the risk of burns, fire, electric shock, or injury to persons:
This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run
with the circuit conductors and connected to the equipment-grounding terminal or lead on the product.
USER-MAINTENANCE INSTRUCTIONS
GROUNDING INSTRUCTIONS
10. To disconnect, turn all controls to the off position, then remove fixture from wall and disconnect grounded branch
6368 Clark Avenue, Dublin, CA 94568
925.245.9220 - fax: 925.245.9203 - 1.800.639.6864
