6
Function / Operating Introduction
1) Start Mode: Set the start mode on the controller
(1) Independent
press-plate mode
(2) Independent
press-down mode
(3) Both available
2) LED Lighting: Set tool lighting on the controller
(1) Start lighting
(2) Continuous lighting (3) Shut down
3) Signal light
4) Button Switch: Turn on and off the setting for screw removal, there will be no OK or NG signal action when
screw removal is in action.
It is recommended to set the direction on the controller first, before setting screw removal, which includes CW
and CCW. Please refer to the following table for 9-level torque and speed setting. The torque to remove screw
should be larger than that to fasten screw. For detailed controller setting, please refer to KL-TCG controller
operating manual.
5) Attaching / detaching bit and bit type
Pull down the holder clamp by fingertip, and it will be unlocked. Thus, the bit can be freely attached and detached
(Single finger notion type) select such a bit whose shank is equal to the size shown below.
6) LED Lighting
auxiliary lighting
Please refer to the KL-TCG operation manual for setting adjustment.
7) Front Cover Thread: fixed auxiliary arm use.
8) Press-plate Start.
pressed down sensor screwdriver starts functioning when the switch trigger has been pressed down; on the contrary, it
stops when the screw has been tightened up or the trigger has been released.
Number
Product Name
Description Use
(1)
Hanging Hole
Hanging hole is available, to hang the screwdriver
(2)
Signal Light
Display OK light, NG light, screw removal start
and stop signal
(3)
Button Switch
Switch rotation direction CW/CCW
(4)
Front Lock Ring
Lock stationary gearbox and housing
(5)
Headgear
Load/unload and fixing the screwdriver bits
(6)
LED Lighting
Four holes in total, used as auxiliary lighting
according to setting
(7)
Front Cover Thread Help to fix on the auxiliary arm
(8)
Press-plate Start
Press to start the screwdriver
OK Light
NO Light
Controller:
Program setting
Direction
Screwdriver light
signal (action)
Controller setting
Edit work order setting
Screw removal setting
Screwdriver light
signal (action)
CW
Forward
CW
Forward
CCW
Backward
CCW
Backward
CCW
Backward
CW
Forward
CW
Forward
CCW
Backward
(1)
(3)
(8)
(4)
(5)
(2)
(7)
(6)
