9
To adjust the torque on these screwdrivers. Proceed as follows :
1. Determine the torque output of the tool by checking a tightened Fastener with a torque wrench.
2. Increase or decrease the torque by rotating the Spring Adjusting
Ring. Rotating the Ring clockwise to a higher number on the
torque Scale increase torque output while rotating the Ring
counterclockwise to a lower number decreases the torque
output.
3. Check the adjustment with a torque wrench. A number of
Factors will affect torque output from one job to another.
Final torque adjustment should be made at the job through a
of series of gradual increase. Always start below the desired
torque and work upward.
4. Adjust the bit torque by changing the driving in length of the
adjust ring at the end.
5. The relationship between torque scale and bit torque is as
shown
Ring, in the torque diagram. The figures of torque scale do not
indicate bit torque values. However, the clamping torque of
screw itself is different form type, size, material of the screw and
the material of its mating part. Use it as standard to obtain an
appropriate clamping torque.
6. The (Return torque method) in which once-clamped screw is
returned with torque wrench or the like is available as one of
torque control methods however, note that the measured values
by the return torque method generally appear in 10%~30% lower
than the actually clamping torque.
7. The torque checker measures the torque of screwdriver. The
clamping torque of screw itself is different from the clamped
conditions. Understand the correlation between clamping torque
values and the torque checker values perform the torque control properly.
1. Please read the operation manual before you use, and follow safety rules to operate the power controller.
2. The power controller must be used with original KILEWS 6-pin Electric Screwdrivers.
3. SKD-BN203/BN207/BN210 Series electric screwdriver collocates with SKP-32B-60W.
4. Also in reverse rotation, the clutch is turned off in such manner as in normal rotation, stopping the motor
running. Accordingly, when the screw tightened at a large torque, set it to a higher torque scale.
5. The number from zero to eight on the Torque Scale are reference number only and not an indication of
actual torque output .
6. The power supplier will generate low power when the button of the power controller is switched to "LO."
Also, the electric screwdriver's torque output setting value should be adjusted to middle torsion value
accordingly.
7. Please refer to Kilews website http://www.kilews.com for the detail component list.
CAUTION
Torque Adjustment Operation
Summary of Contents for SKD-BN203L
Page 11: ......
