5
Ⅳ
.
The assembly/disassembly method for the Battery Screwdriver
and Battery is shown in the figures below, with description:
Assembly Diagram
(1) As shown by the circle in Figure 1: After the inverted triangle arrow on the screwdriver is aligned
with the positioning line on the Battery, press the screwdriver down with clip latches.
(2) Push the screwdriver as shown in Figure 2 in the direction of Battery clip latch, and you will hear a
click, and the Battery clip latches will fasten the screwdriver.
(3) Assembly is completed.
Awaken
state
Press the trigger to
wake up the
screwdriver
Light
1. When the screwdriver
and the Battery are not
installed in the clip
latches, the indicator
light: flashing in red
and green alternately.
2. The panel light is ON.
1. When the screwdriver
and the Battery are
installed by the clip
latches, the indicator
light: red or green
light is ON~OFF.
2. The panel light is ON.
Buzzer
When the screwdriver
and the Battery are not
installed in the clip
latches, the buzzer
sounds BB continuously.
When the screwdriver
and the Battery are
installed by the clip
latches, the buzzer
sounds BB once
ID identification
If unsuccessful, the
screwdriver disable to
start running after
pressing the trigger.
If successful, the
screwdriver enable to
start running after
pressing the trigger.
Sleep
state
after being awakened
if ID identification is
not performed within
7 seconds, it will go
into sleep mode
Light
no
no
Buzzer
no
no
Positioning
Line
(FIGURE 1)
(FIGURE 2)
(FIGURE 3)
