Kilews KL - SCBSN, User'S Operation Manual

Page: 8 / 10

6
3. Operation Description :
3.1 Panel setting description :
No. Function Description
1
Power / Comm. Error
/ Gate Enable LED
(Red / Blink)
1.
Power on and connected display RED light on
2.
When disconnect or loss communication with screwdriver , display RED light and
blink every 0.5 sec.
3.
When SW1 is ON, the target ready confirm (Gate) function is enabled, display
RED light and blink every 5 Sec.
2
▲+▼
[UP]+[DOWN]
1. Press both
▲
and
▼
button for 2 Sec to enter setting mode, LED display [RC] .
2. Press both button for 1 Sec to change to set next function.
3. LED display [RC]-[-SP]-[Ut]-- Exit.
4. Screwdriver control will be disabled and the power light will flash each 5 Sec
between setting mode.
5. Use
▲
or
▼
button to change the setting value
RC : Slow start time 0.0 ~ 9.9 Sec.
SP : Slow start speed level L0 ~ L9
Ut : Max operation time 0.0 ~ 9.9 Sec.
6. When [Ut] is set,LED will display [Ut] screwdriver will stop and output a brake
signal when [Ut] time is up.
3
▲
[UP]
1. Press
▲
button for 6 sec to reset to factory default values
(RC:0.0
，
SP:L0
，
Ut:0.0)
4
OUTPUT START
LED (Green)
1. Turn ON to indicate screwdriver is running
2. Turn OFF when screwdriver is stop
5
OUTPUT STOP
(BRAKE)
LED (Green)
1. Turn ON to indicate Brake signal.
2. When SW 2 is ON, Brake signal will off when start switch is released
3. When SW 2 is OFF, Brake signal will keep until next start switch is pressed
6
OUTPUT
REVERSE LED
(Green)
1. Turn ON to indicate screwdriver run in reverse
2. Turn OFF when screwdriver run in forward
7
INPUT START
LED (White)
1. Turn ON to indicate screwdriver is started by external start signal input
2. Turn OFF when external start input signal is off
8
INPUT REVERSE
LED (White)
1. Turn ON to indicate screwdriver is started in reverse by external reverse start
signal input
2. Turn OFF when external reverse start input signal is off
9
Slow Start &
Running Time
Control Switch
1. Toggle this switch to disable or enable both [RC] [SP] and [Ut] functions, LED
display will turn off when function is disabled.
2. If function is enabled, LED will display [NO] , [L1] ~[L9] or [Ut] depands on the
setting status.
6
5
4 8 7
2 3
1
9
Slow Start &
Running Time Control Switch