6
4. Remove the equipped jig plate, and place it at the rear of the track after assembly according to
Table b
, then fasten the screws removed in
Step 2
.
※
The assembly method is provided for reference only
※
Table b
Screw dimension
(mm)
Sheet of thickness at the
rear of track (mm)
Screw dimension
(mm)
Sheet of thickness at the
rear of track (mm)
1.0
0.5 * 2 + 0.2 = 1.2
2.6
0.2 + 0.5 * 5 = 2.7
1.2
0.5 * 2 + 0.2 * 2 = 1.4
3.0
0.2 + 0.5 * 6 = 3.2
1.4
0.5 * 3 = 1.5
3.5
0.2 + 0.5 * 7 = 3.7
1.7
0.2 * 2 + 0.5 * 3 = 1.9
4.0
0.2 + 0.5 * 8 = 4.2
2.0
0.2 + 0.5 * 4 = 2.2
5.0
0.2 + 0.5 * 10 = 5.2
2.3
0.2 * 2 + 0.5 * 4 = 2.4
5. After adjustment is complete, take a screw and place on the track, followed by sliding it from
the rear toward the front. It is acceptable if the screw is able to slide smoothly.
Notes
a. Please ensure the middle of the tracks is flat and parallel, and adjustment to narrow front with
wide rear or vice versa is prohibited.
b. If it is a screw of
1 = 1
or
1 < 1
, then it shall be adjusted to narrow front and wide rear, and the
dimension of the wide rear shall be greater than the total length of the screw.
c. During the adjustment of the clearance at the front of the tracks, the screws in
Step 1
shall be
fastened flatly.
