PMX_MULTI
User’s Manual
61
External Control
CONTROL TERMINAL
The CONTROL TERMINAL is a screw-less terminal.
The parts necessary to connect to the CONTROL TERMINAL are not included. Use parts that match the
connector to make the connections.
For information about how to obtain these tools or replacement parts, contact your Kikusui agent or distrib-
utor.
Connecting the CONTROL TERMINAL
Cables and tools that are necessary to make the connection
1
Turn the POWER switch off.
2
Remove 8 mm of the wire covering, and connect the wire to the CONTROL TERMI-
NAL.
3
Remove the screwdriver, and check that the wire does not come loose.
This completes the connections.
Wire
Single wire: Ø0.32 (AWG28) to Ø0.81 (AWG20)
Stranded wire: 0.08 mm
2
(AWG28) to 0.52 mm
2
(AWG20)
Flat-blade screwdriver
Tip thickness: 0.5 mm
Wire stripper
A wire stripper that matches the wires listed above
WARNING
Risk of electric shock and damage to internal circuits.
• Never connect to the CONTROL TERMINAL while the POWER switch is turned on.
• Insert the cables so that the wire strands do not touch the chassis when they stick
out of the CONTROL TERMINAL. Also, insert the cables so that the stripped wires
do not stick out of the terminal block.
• For connecting to the CONTROL TERMINAL, use cables with a voltage rating that is
higher than the product’s isolation voltage. For details on the isolation voltage of
each model, see “Specifications”
AWG20-28
STRIP-
GAUGE
8mm
17
8
1
3
CONTROL TERMINAL
Incorrect
Incorrect
Correct
The wire itself is
in contact with the
chassis.
Wire scraps are
in contact with the
chassis.
While pressing
here with a
screwdriver, insert
the wire.
