4
PLZ-5W SR Series Setup Guide
When using this product, be sure to observe the “Safety
Precautions” in the Safety information manual. The fol-
lowing precautions pertain only to this product.
• The rear panel may become hot during operation. If you
touch it, you may burn yourself.
• Do not use the product where ventilation is poor. Heat is
expelled from vents of the rear panel. To prevent the heat
from building up and causing a fire, keep the vents at least
60 cm away from walls. Also, do not place objects within
60 cm of the rear panel.
When installing this product, be sure to observe the “Pre-
cautions Concerning Installation Location” in the Safety
information manual. The following precautions pertain
only to this product.
• When installing this product, be sure to observe the tem-
perature and humidity ranges indicated below.
Operating temperature range: 0 °C to 40 °C (32 °F to 104 °F)
Operating humidity range: 20
%rh to 85
%rh (no condensa-
tion)
• When storing this product, be sure to observe the tempera-
ture and humidity ranges indicated below.
Storage temperature range: -20 °C to 70 °C (-4 °F to 158 °F)
Storage humidity range: 90
%rh or less (no condensation)
Fixing the product in place
This product has casters on its bottom side, so it is easy to
move the product. To ensure that the product is not moved
accidentally while it is being operated, lock the casters, and fix
the product in place by lowering the stoppers to the floor.
When moving this product, be sure to observe the “Pre-
cautions to Be Taken When Moving the Product” in the
Safety information manual. The following precautions
pertain only to this product.
• If the stopper bolt has been used to fix the product in place,
release the stopper. Moving the product without releasing
the stopper may cause injuries due to the product falling
over.
• When you are moving the product from one location to
another, if you must leave it unattended, be sure to use the
caster locks or the stopper bolt to ensure that the product
stays in place.
• If you are using a forklift to move the product, be sure to
slide the forks under the bottom of the product, check that
the product is stable, and then raise the product. If you are
using a crane to move the product, be sure to slide the band
under the bottom of the product, check that the product is
stable, and then raise the product.
• Do not use the handles to lift the product. The handles are
for moving the product on its casters. The handles are not
strong enough to support the weight of the product.
• Do not tip the product on its side or turn it upside down.
Safety Precautions
Precautions Concerning
Installation Location
Lock
Release
Caster lock
Caster lock
Stopper bolt’s bottom nut (M12)
• Turn the nut clockwise to lower the stopper (lock).
• Turn the nut counterclockwise to raise the stopper (unlock).
• Turn the nut clockwise to
fix the stopper position in
place.
Stopper bolt’s top nut (M12)
Precautions to Be Taken
When Moving the Product
