Kikusui KDS6-0.2TR, Operation Manual

Page: 17 / 60

KDS6-0.2TR Prior to Use 13
1.5 Connecting the Power Cord
Connect the power cord to the KDS6-0.2TR.
Insert the 3-pole plug with ground on the cord supplied with the KDS6-0.2TR into
an outlet.
The KDS6-0.2TR is designed for connection to a power supply of Overvoltage Cat-
egory II.
• The power cord for 100 V system shown in Fig. 1-3 has a rated voltage of
125 VAC. If this power cord is used at the line voltage of a 200 V system,
replace the power cord with that satisfying that line voltage.
An appropriate power cord must be selected by qualified personnel. If it is
difficult to obtain the power cord, consult Kikusui distributor/agent.
• Connect the KDS6-0.2TR to an AC power line corresponding to the
required input power.
• Do not use the power cord supplied with the KDS6-0.2TR for other appara-
tuses.
Fig. 1-3 Power cord
Connect the power cord as follows:
1. Turn the POWER switch off.
2. Connect the power cord to the AC inlet located on the rear panel.
Use the power cord designated by Kikusui or one selected by qualified person-
nel.
3. Insert the plug of the power cord into the outlet.
WARNING
CAUTION
Power cord for 100 V system
[85-AA-0003]
Rated voltage: 125 VAC
Rated current: 10 A
Power cord for 200 V system
[85-10-1070]
Rated voltage: 250 VAC
Rated current: 10 A