Kiev-19M Instructions for Use
– 10 –
4.8. Installation of Dioptric Lens
If it is necessary use the dioptric lens in shooting. It is inserted into the mounting of the eyepiece
protective glass.
To install the dioptric lens unscrew the mouting with protective glass
23
, remove the spring ring
and take out the protective glass. Install the dioptric lens on the protective glass place and insert the
spring ring.
The dioptric lens diameter is 18 mm.
Bear in mind that the camera viewing system has the minus 1 diopter.
4.9. Replacement of Power Source
When the voltage of the power source drops below an admissible level, the signals in the field of
vision of the viewfinder go out or when the exposure parameters are set to the NORM position the
signals begin to blink. In this case replace the power source.
To replace the power source do as follows:
open cover
21
by moving it in the direction of the arrow (ref. to Figure);
by pulling the tape end take the faulty power source out from the recess;
install a new power source observing the polarity shown on the cover;
check the power source for operation by pressing cover
5
.
4.10. Installation of Attachment
For convenient holding the camera without the case it is possible to install ergonomic attachment
30
which is fixed on the camera body by screw
31
.
5. Acceptance Certificate
It is hereby certified that KIEV-19M camera, Serial No.
with lens No.
meets the requirements of the engineering documentation and is found fit for service.
Date of release
Signatures of persons in charge of acceptance
http://eugigufo.net/it/download/photovideo/
