A
Page 20 / 22
Product Description
MD15-FTL-HE, MD15-FTL-OV
Datasheet 3.09-20.315-01-EN
Issue 2017-01-09 Rev 1
Switching the Energy Block Feature (Automatic “Window Open” Recognition) On and Off
►
Press the push-button (2) and hold it until you hear 4 successive signal tones and the status LED
flashes green 4 times.
►
Release the push-button.
After the push-button (2) is released, the current status (on or off) is indicated visually and acousti-
cally.
■
Energy block feature on:
Status LED flashes green 2 times and 2 signal tones are emitted
■
Energy block feature off:
Status LED flashes red for approx. 1 s and a long signal tone is emitted
►
To change the status, you must again press and release the push-button (2) within the next 5 s.
The new function setting, either “energy block feature on” or “energy block feature off,” is
indicated visually and acoustically as described above.
Factory setting:
On
Setting the Radio Communication Interval
The transmission or reception interval can be set in increments of two minutes.
►
Press the push-button (2) and hold it until you hear 5 successive signal tones and the status LED
flashes green 4 times and orange 1 time.
►
Release the push-button (2).
The new radio communication interval is acknowledged again both visually and acoustically;, siehe
Tabelle 1.1. "Radio communication interval".
►
To change the radio communication interval, you must press the push-button (2) again within
thenext 5 s and release it once the desired radio communication interval is reached.
This is indicated visually and acoustically, siehe Tabelle 1.1. "Radio communication interval".
►
Release the push-button (2).
The new radio communication interval is acknowledged again both visually and acoustically;
see Table 1.1 "Radio communication interval".
Default setting:
Transmission and reception interval: 10 min
Tab. 1: Radio communication interval
NOTE
If you press and hold the push-button (2) until 6 successive signal tones are heard and the status LED
flashes 6 times, the status LED lights up red and a long signal tone (approx. 1 s) is emitted to indicate
the end of the setting procedure.
Radio com-
munication
interval
Signal
2 min
Status LED flashes 1 time and 1 signal tone is emitted
4 min
Status LED flashes 2 times and 2 signal tones are emitted
:
:
20 min
Status LED flashes 10 times and 10 signal tones are emitted
