7.
Insert the motor
(F)
into the motor holder as shown. Make sure the wires are
aligned according
to the
diagram.
Place the motor
cover
(E) over
the motor and secure it with 2 small screws. Then slide the
motor's
red and black wires
through
the hole at the front of the
motor holder to prepare for the next step.
8.
Insert the red wires into the terminal closest to the “ON”
marking
on the battery case and secure them in
place
with a terminal
cap (N).
Repeat this process with the black wires in the other terminal. Refer to the diagram to ensure the wires are connected correctly.
9. Attach the battery case to battery case joint (I) with 4 small screws.
10. Slide the propeller (L) onto the motor's axle.
11. Attach the battery case joint to the top of the racer body with three flat top screws (O).
12. Make sure the switch is in the "OFF" position before inserting the 4 x 1.5 V AAA batteries into the battery case.
1. Slide the long axle (C) into the rear axle support (B) as shown.
2. Make sure the
long axle
is centered. Then insert a metal eyelet
(M) over
one end of the
long axle
and
press
it into the side of the rear
axle support. Repeat on the other side.
3. Snap a back wheel (J) onto each end of the long axle.
4.
Flip
the body
over,
and then attach the rear
axle support
to the back four holes on the racer body
(A)
with 4 small screws
(P)
as
shown. The smooth side of the rear axle support and racer body should face downwards when attaching the two pieces together.
5.
Attach the front wheel
(K)
to the three holes at the front of the racer body with
3
small screws. The flat side of the front
wheel's
screw
holes should face away from the racer body.
6. Attach the motor holder (D) to the top of the battery case (H) with 3 small screws.
D. ASSEMBLY
1.5 V
AAA
-
+
1.5 V
AAA
-
+
1.5 V
AAA
-
+
1.5 V
AAA
-
+
OFF
ON
I
A
B
C
E
F
H
J
L
K
M
N
O
P
D
1
2
7
8
9
10
11
12
3
4
5
6
1.5 V
AAA
-
+
1.5 V
AAA
-
+
1.5 V
AAA
-
+
1.5 V
AAA
-
+
OFF
ON
I
A
B
C
E
F
H
J
L
K
M
N
O
P
D
1
2
7
8
9
10
11
12
3
4
5
6