KIDWELL MAVI, User Manual

Page: 24 / 44

24
To assemble the seat, connect the backrest hooks to the seat while holding the backrest
horizontally. When the hooks are in the slots of the base, start raising the backrest to
a vertical position. Add pressure to the base so that it will not slide away, and press the
backrest towards the base to avoid the hooks from escaping.
ATTENTION: make sure that the backrest of the seat is well connected to the base
before it is installed in the car.
WARNING: The installation for group I is forward facing
IMPORTANT: The 3-point harness safety belt is used only to lock the car seat in place.
The child should be secured by 5-point harness safety belt which is apart of the car seat.
A. Place the safety seat in a forward facing position in the car and make sure that
it adjoins the car seat backrest.
B. Pass the belt through the slots (see product components, no.9), from the front
to the back, then guide the belt behind the backrest of the seat, and from the back
to the front. Once done, fasten the seat belt.
C. Beginning of the 3-point belt, the hip part should pass under the armrest.
Beginning of the 3-point belt, the shoulder part should pass under the headrest of
the seat.
D. Push the backrest into the vehicle seat while tightening the shoulder belt. Pull the
belt towards the retraction and harnesses as much as possible.
WARNING: Make sure that the seatbelts are well tightened and not twisted.
WARNING: Make sure that the seat cover does not block the seatbelts in any way.
ASSEMBLY
INSTALLATION FOR GROUP I (9-18 kg)
2
3
When fastening the harness belts, make sure that the hip strap and shoulder strap fi t
properly. Too much freedom or too tightly fastened straps can be a threat to the child.
Harness adjustment hole should be located at the height of the child’s shoulders or
slightly higher.
A. In order to loosen the harness straps, push the central adjusting button which is
located in the center part of the safety seat (see Product Components, element 3).
While pushing the central adjusting button, pull the shoulder straps in order to
extend their length.
B. Push the central harness buckle button to unfasten the harness. Adjust the length
in a way that both, the right and the left shoulder strap are the same length.
C. While fastening the harness, make sure that the hip strap and the shoulder straps
ADJUSTING AND SECURING 5-POINT BELTS
4