22
“Movement is life!”
K. SHELL REMOVAL AND INSTALLATION
1. Shell
Removal
a. Engage the wheel locks.
b. Turn the ACTIVE handle to the OFF position.
c. Remove the child from the chair.
d. Lift up on the front of the seat pan [C].
e. Pull up the hip angle adjustment lever [D].
f. Lift shell assembly upward and out of mobility base.
2. Shell
Installation
a. Lower shell assembly into mobility base so that pivot bushings [E]
enter slot [F] (
Fig. 42
).
b. Pull up the hip angle adjustment lever [D] and adjust the shell to the
desired hip angle position. Engage lever. Check for proper pin en-
gagement and lever position. - refer to page 17, section C.
c. Turn ACTIVE lever to the ON position and cycle ACTIVE motion
to ensure proper installation.
d. Apply forward pressure to the handlebar and turn the ACTIVE
lever to the off position.
Figure 37: Shell Assembly [A]
Figure 38: Mobility Base [B]
C
D
Figure 39: Lift up on front of seat pan.
Figure 40: Pull hip angle adjustment lever
and lift up.
WARNING: Always remove the child from the chair
prior to removal of the shell assembly [A] from the
mobility base [B]. Removal of the shell assembly is
only intended for lifting and transportation of the
chair. The child should never be placed in the shell as-
sembly if it is not properly attached to the mobility
base. The mobility base should never be used without
the shell assembly properly installed.