to “chirp” approximately every 30 - 40 seconds for a minimum of
seven (7) days when the battery gets low. Replace the battery
when this condition occurs. These batteries are available at many
local retail stores.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE
ALARM REPLACEMENT.
Carbon Zinc Type:
EVEREADY 1222; GOLD PEAK 1604S
Alkaline Type:
ENERGIZER 522; DURACELL MN1604,
MX1604, GOLD PEAK 1604A; PANASONIC
6AM6, 6AM-6, 6AM-6PI, 6AM6X,
and 6LR61(GA)
Lithium Type:
ULTRALIFE U9VL-J
NOTE: WEEKLY TESTING IS REQUIRED.
WARNING!! USE ONLY THE BATTERIES SPECIFIED. USE OF
DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL EFFECT
ON THE SMOKE ALARM.
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as out-
lined in the beginning of this section (If tamper resist feature has
been used, refer to “REMOVING ALARM WITH TAMPER RESIST
FEATURE ACTIVE” in section 3 for removal instructions).
You can clean the interior of your alarm (sensing chamber) by
using compressed air or a vacuum cleaner hose and blowing or
vacuuming through the openings around the perimeter of the
alarm. The outside of the alarm can be wiped with a damp cloth.
After cleaning, reinstall your alarm and test your alarm by using
the test button. If cleaning does not restore the alarm to normal
operation the alarm should be replaced.
Do not paint your alarm. Paint will seal the vents and interfere
with the alarms ability to detect smoke and produce sound. Never
attempt to dismantle the alarm or clean the inside, as this will void
the warranty.
