15
Troubleshooting Guide
1
POSSIBLE CAUSE: The battery may be low on power.
•
After each use, or once a month minimum, charge the battery for a “full” 16
hours. DO NOT leave the battery on the charger for more than 30 hours. See
pages 4-5 for recharging warnings and instructions.
2
POSSIBLE CAUSE: Thermal fuse has tripped.
•
The 6-volt battery features a thermal fuse with a reset fuse in the engine
connector that will automatically trip and cut all power to the Scooter if the
motor, electrical system or the battery is overloaded. The fuse will reset and
power will be restored after approximately 15 seconds. See page 14 for tips to
avoid tripping the thermal fuse.
3
POSSIBLE CAUSE: Engine connector or wires are loose.
•
Make sure the engine connector is firmly plugged into the battery. If you find loose
wires around the motor, call
Pacific Cycle, Inc.
Consumer Relations at
(877) 741-6154
for an authorized service center.
4
POSSIBLE CAUSE: Battery is dead.
•
Have you properly maintained the battery according to the directions? Is the
battery old? Your battery may need to be replaced. Refer to the Battery
Maintenance instructions on page 14.
5
POSSIBLE CAUSE: Electrical system is damaged.
•
Water may have corroded the system, or loose dirt, gravel or sand might
have jammed the switch. Call
Pacific Cycle, Inc.
Consumer Relations at
(877) 741-6154
for an authorized service center.
6
POSSIBLE CAUSE: Motor is damaged.
•
The Scooter needs professional repair. Call
Pacific Cycle, Inc.
Consumer
Relations at
(877) 741-6154
for an authorized service center.
Having problems with your Scooter? Read through this troubleshooting guide for
solutions to common problems. If you still experience problems, call
Pacific Cycle, Inc.
Consumer Relations at
(877) 741-6154
for an authorized service center.
PROBLEM: The Scooter does not run.
1
POSSIBLE CAUSE: Engine connector or adapter connector is loose.
•
Make sure the engine connector and the adapter connector is firmly plugged into
the battery.
2
POSSIBLE CAUSE: Charger is not plugged in.
•
Make sure the charger is plugged into the wall outlet and the power flow to the
outlet is on.
PROBLEM: The 6-volt battery will not recharge.
