6
Figure 2
Control Panel Shield
Mounting Bracket
Nine (9) Supplied
Screw Insulators
Nine (9) Supplied
#10 (5mm) screws
Mounting Bracket
Warhorse Amplifier
Mounting Holes
Control Panel
(Top View)
Remove the two (2) screws
securing the control panel
shield to the amplifier chassis.
Remove the control panel shield from the
amplifier so the mounting holes on the bottom
plate of the control panel will be accessible.
Before mounting the amplifier, be sure there is adequate space in the mounting position
to take the control panel shield on or off and to easily access the amplifier’s controls.
After determining the best mounting position for the amplifier, use the mounting bracket as a template to drill
nine (9) holes with a 3/16” (4.8mm) bit into the appropriate locations. Attach the bracket to the mounting
location with the nine (9) supplied #10 (5mm) screws inserted through the nine (9) included screw insulators.
Slide the Warhorse over the mounting bracket and insert the mounting
bracket into the mounting slot on the bottom of the amplifier.
Locate the additional mounting holes on the bottom plate of the control panel. Use the mounting holes as a template
to drill two holes using a 3/16” (4.8mm) bit into the appropriate locations. Secure the bottom plate of the control panel
with the two (2) #10 (5mm) screws. You are solely responsible for securely fastening the amplifier in your vehicle.
INST
ALLA
TION
1.
2.
3.
4.
5.
The amplifier is very heavy.
Assistance may be necessary
to lift and position the amplifier.
