4
Subwoofer Input Connection without Optional Amplifier
15. Connect the six inch adapter harness to the end
of the two- pin connecter. Locate position 40 and
position 32 on the radio connecter and install
one of the wire taps onto the wire. Lay the wire in
the open channel, fold the connecter body over
and squeeze with a pair of pliers until connecter
snaps shut, Fig 7. Connect the green wire of the
adapter harness to the wire in position 40, and
the brown wire to the wire in position 32
NOTE: If you are installing the optional amplifier system, route the power and ground wires
of the amplifier body harness under the carpet and toward the driver’s side kick panel at
this time.
16. Connect the power connecter to the power wire
coming through the firewall grommet and tuck
out of the way.
17. Connect the black ground wire to the factory
ground point near the driver’s side kick panel.
Torque to 9 +/- 1.5 Nm. Fig. 8
18. Continue running the subwoofer harness down
the driver’s side of the car to and under the rear
seatback. It is helpful to rotate the seatback
down to allow clearance for the connecters.
Secure any excess harness to the factory
harness under the driver’s side rear threshold
panel.
Subwoofer Installation Hatchback
19. Remove the spare tire to retrieve the spare tire
safety strap equipped with the vehicle, and then
replace the spare tire. (Refer to owner’s manual,
beginning in section 10-67, for proper removal
and reinstallation of spare tire.) The safety strap
will be used to insure the sub- woofer enclosure
does not strike someone in the event of a
collision.
Fig. 7
Fig. 8
Connect
ground
wire
here
Fig. 9
Install
foam
strip
here
