3
Subwoofer Harness Routing
6.
Remove the driver’s side kick/threshold panel by
loosening the retainer at the top and then pulling
loose. Fig. 4
7.
Remove the lower portion of the rear seat by
pulling straight up on the front edge.
8.
Snap loose the rear driver’s side threshold panel
located along the bottom of the door opening.
9.
Snap loose the lower portion of the B pillar post
cover.
10.
Remove the driver’s side cover directly in front of
the console by removing the plastic retainer with
a Phillip’s screwdriver and then pull the cover
loose. If installing the optional amplifier system, the passenger’s side panel will need to be
removed as well but has no plastic retainer and can simply be pulled off. Fig. 5
11.
Remove the radio trim bezel by carefully prying loose with a plastic panel removal tool.
Start at the corners and work around the bezel. Fig. 6
12. Remove the four screws securing the radio, pull radio from dash and disconnect all wiring.
13.
Route the white two pin connecter of the subwoofer harness up to the radio opening from the
driver’s side of the console
NOTE: If installing the optional amplifier system, route the amplifier harness at this time.
Subwoofer Input Connection with Optional Amplifier
14. Connect the white two-pin connecter of the subwoofer harness to the corresponding
connecter of the amplifier harness at this time.
Fig. 4
Retainer
–
Rotate
counterclockwise
Fig. 5
Fig. 6
