Page 5 of 10
Fig. 12
Fig. 13
A
Fig. 12
19.
Remove the two 10mm bolts temporarily installed in step 11. Position the previously removed metal
plate over the top of the amp bracket and secure both with the two 10mm bolts.
20.
Tighten the bottom bolt.
21.
Loosen the four screws indicated by the arrows in Fig. 12 approximately 4 turns. Fig. 12
22.
Remove the screw indicated by arrow A completely. Fig. 12
23.
Install the amplifier with the long tab toward the center of the car. Slide the long tab behind the
plastic and under the lower right screw while pulling out on the plastic. Once tab is completely
seated rotate the amplifier down and secure the short tab in the same manner. Reinstall screw A
and retighten the screws but leave the covers uninstalled. Fig. 13
Power Harness Installation
24.
Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it.
Fig. 12
25.
Using a razor knife make a small cut in the center of the grommet. Pass the power wires with the
small terminals on the ends through the grommet and then pull the grommet up to the point where
the plastic sheathing starts. Fig. 13
26.
Run the wires through the grommet hole in the fire wall and reinstall the grommet.
27.
Run the wires along the top of the fire wall toward the battery and secure with wire ties.
28.
Remove the top of the fuse cover and using a 13mm socket and ratchet loosen and remove the nut
on the positive battery accessory lug. Fig. 14
29.
Connect the ring terminals of the power harnesses to the lug and retighten the nut. Torque to 10Nm.
30.
Using a panel removal tool remove the four plastic retainers (three in front door opening and one in
rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 15
Fig. 13
