Page 4 of 10
Fig. 7
Fig. 9
Fig. 8
12.
Place the amp on top of the bracket by sliding it under the dash past the brake pedal. Make sure the
connecters on the amp are facing toward the fire wall and the mounting holes are facing down.
13.
Using a Torx® T-25 screwdriver install the four supplied screws and washers to attach the amp to
the amp bracket. Fig. 9
14.
Pass the factory radio harness connecter behind the metal framework indicated by the arrow. Fig. 10
15.
Connect the amplifier harness to the amplifier and route the harness up to the radio cavity.
16.
Connect the male radio harness connecter to the female connecter of the amp harness and tuck this
connection into the void between the radio opening and the instrument cluster to avoid interference
with radio during reinstallation.
17.
Route male connector of the amp harness back around the beam as the radio harness originally
was. Fig. 11
18.
You can now connect the radio to the amplifier harness and reconnect the antennae wire and
reinstall the radio.
Fig. 10
Fig. 11
