SWRA406 - ©2012 Stillwater Designs
9-27-12
Page 3 of 8
Fig. 5
Fig. 6
Fig. 7
Fig. 8
11.
Remove the top of the fuse cover and using a 13mm socket and ratchet loosen and remove the nut
on the positive battery accessory lug. Fig. 7
12.
Connect the ring terminal of the power harness to the lug and retighten the nut. Torque to 10Nm.
13.
Using a panel removal tool remove the four plastic retainers (three in front door opening and one in
rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 8
14.
Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
15.
Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to
prevent the connector from accidentally coming disconnected.
16.
Route the harness along the bottom of the front and rear door jam and toward the back seat.
Subwoofer Input Connection without optional amplifier installed
17.
Locate the left front lower dash speaker wires on the back of the plastic speaker housing. The wire
colors are gray with a yellow stripe and gray with a purple stripe. Fig. 9
18.
Install one of the self stripping t-tap connectors on to each wire. Lay the wire in the open channel,
fold the connector body over and squeeze with a pair of pliers until connector snaps shut. Fig. 10
19.
Connect the subwoofer harness input wires to the t-tap connectors. The green wire (positive) of the
harness connects to the t-tap connector on the gray wire with the yellow stripe in the vehicle. The
brown wire (negative) of the harness connects to the t-tap connector on the gray wire with the purple
stripe in the vehicle.
Subwoofer Input Connection with optional five-channel amplifier installed
20.
Connect the two pin connector of the amplifier harness to the two pin connector of the subwoofer
harness.
