SWRA406 - ©2012 Stillwater Designs
9-27-12
Page 2 of 8
Fig. 1
Fig. 2
A
Fig. 3
Subwoofer Installation
1.
Disconnect the negative battery cable.
2.
Gently pull out on the panel just below the steering column, rotate down and remove. Fig. 1
3.
Find the small panel just below the one you just removed and pull to remove it as well. Fig. 2
4.
Loosen the four screws indicated by the arrows in Fig. 3 approximately 4 turns. Fig. 3
5.
Remove the screw indicated by arrow A completely. Fig. 3
6.
Install the amplifier with the long tab toward the center of the car. Slide the long tab behind the
plastic and under the lower right screw while pulling out on the plastic. Once tab is completely
seated rotate the amplifier down and secure the short tab in the same manner. Reinstall screw A
and retighten the screws but leave the covers uninstalled. Fig. 4
7.
Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it.
Fig. 5
8.
Using a razor knife make a small cut in the center of the grommet. Pass the end of the wire with the
small terminal on the end through the grommet and pull the grommet up to the point where the
plastic sheathing starts. Fig. 6
9.
Run the wire through the grommet hole in the fire wall and reinstall the grommet.
10.
Run the wire along the top of the fire wall toward the battery and secure with wire ties.
Fig. 4
