4
solobaric L7 Enclosures
Installa
tion
After determining the best mounting position, check carefully in
the areas where the mounting brackets will go. Make very sure
that the mounting screws will not puncture the gas tank, brake
lines, etc., or interfere with any mechanical items on the
underside of the chosen mounting surface. Turn the enclosure
upside-down and attach the four mounting brackets to the bottom
of the enclosure using the supplied smaller screws. Each bracket
must be positioned so the rounded end protrudes approximately
3/4" from under the cabinet to allow a screw to easily pass
through it for attachment to the vehicle.
Mount Brackets with supplied screws
on each side of enclosure
Plug your subwoofer speaker wire into the terminals, using the
red connector as positive and the black connector as negative.
Hook the other end of this wire to your subwoofer amplifier in
accordance with its owner's manual.
NOTE:
This enclosure is wired internally to make a 4 Ohm load
at the terminals.
With the enclosure right side up, securely attach it to the
vehicle with the supplied larger screws.
If the supplied hardware is not applicable to your installation,
some other means of securely attaching the enclosure to the
vehicle must be used.
To avoid potential injury from forward
movement of the enclosure during abrupt
stops or accidents, this enclosure must be
properly installed and securely fastened to
your vehicle.
