7
Fig 24
Cargo Tray Removal
32. If the vehicle is equipped with a fold-out cargo tray under the rear seat, the driver’s side
portion will need to be removed to allow the subwoofer to install. To remove the cargo tray,
remove the two smaller nuts in the rear. Fig. 20
33. Fold the tray up and remove the two seat bolts and then remove the tray. Fig. 21
34. For vehicles equipped with one-piece rear bench seats remove the 18mm bolt securing the
driver’s (left) side of the seat to the floor.
35. For one-piece rear bench seat, you will also need to find the threaded nut insert in the floor
pan concealed by the carpet flap. Fig. 22
36. Set the enclosure in place and reinstall seat bolts (a bolt is supplied for one-piece bench
seats) and tighten. Torque to 30 ft/lbs. Fig. 23
37. Route the subwoofer harness behind the plastic
trim panel on the end of the rear seat and under
the driver’s side rear outermost seat bracket.
Fig.24
38. Connect the four-pin plug of the subwoofer
harness to the subwoofer enclosure.
39. Reinstall all previously removed parts in reverse
order.
40. Install the supplied fuses in the fuse holders under
the hood.
41. Reconnect the negative battery cable. Torque to
5Nm.
Fig 20
Fig 21
Fig 22
Fig 23