6
Fig 15
Subwoofer Amplifier Mounting without Air Bag Control Module
Note: The Air Bag Control Module is located
under the driver’s seat on certain model
trucks. The amplifier/bracket assembly as
shipped will not install if the Air Bag Control
Module is present. If the truck is equipped
with the Air Bag Control Module, skip to steps
26-29
25. Remove the two 8mm bolts holding the bracket for
the seat wiring. Mount the amplifier/ bracket
assembly as shown in Fig.15
Subwoofer Amplifier Mounting with Air Bag Control Module
26. Remove the subwoofer amplifier from its current bracket by removing the four screws and
pulling the connector loose. Fig 16
27. Reattach the subwoofer bracket to the alternate bracket using the original screws. Fig. 17
28. Remove the two M6 nuts securing the air ride control module. Fig 18
29. Install the amplifier bracket over the studs and reinstall the M6 nuts. Torque to 5Nm. Fig. 19
30. Connect the ten-pin connector of the harness to the amplifier. Slide the red locking tab over
to prevent the connectors from accidentally becoming disconnected.
31. Route the subwoofer four-pin connector toward the rear seat.
Fig 16
Fig 17
Fig 18
Fig 19