2
KXM.5-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting:
Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no
items behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of
open ventilation for the amplifi er. Drill four holes using a 7/64” (3mm) bit and use the supplied #8 screws
to mount the amplifi er.
PERFORMANCE
MODEL: KXMA800.5
IMPORTANT SAFETY WARNING
PROLONGED CONTINUOUS OPERATION OF AN AMPLIFIER, SPEAKER, OR SUBWOOFER IN
A DISTORTED, CLIPPED OR OVER-POWERED MANNER CAN CAUSE YOUR AUDIO SYSTEM
TO OVERHEAT, POSSIBLY CATCHING FIRE AND RESULTING IN SERIOUS DAMAGE TO YOUR
COMPONENTS AND/OR VEHICLE. AMPLIFIERS REQUIRE UP TO 4 INCHES (10CM) OPEN
VENTILATION. SUBWOOFERS SHOULD BE MOUNTED WITH AT LEAST 1 INCH (2.5CM)
CLEARANCE BETWEEN THE FRONT OF THE SPEAKER AND ANY SURFACE.
Model:
KXMA800.5
RMS Power,
AMP1
and
AMP2
@ 14.4V, 4Ω stereo, ≤ 1% THD+N
@ 14.4V, 2Ω stereo, ≤ 1% THD+N
@ 14.4V, 4Ω mono, ≤ 1% THD+N
50W x 4
100W x 4
200W x 2
RMS Power,
SUB
channel
@ 14.4V, 2Ω mono, ≤ 1.5 % THD+N
@ 14.4V, 4Ω mono, ≤ 1.5 % THD+N
400W x 1
200W x 1
Length [in, cm]
12-3/4, 32.4
Height [in, cm]
2-1/8, 5.5
Width [in, cm]
8-5/16, 21
Frequency Response [Hz]
AMPS 1-2:
10Hz–20kHz
SUB:
10Hz–160Hz
Signal-to-Noise Ratio [dB]
>95dB, A-weighted, re: rated power
Input Sensitivity
250mV–10V
Selectable Electronic Crossover
AMP 1:
OFF/HP/LP, variable 10–5,000Hz with 10X switch;
24dB/octave
AMP 2:
OFF/HP/LP/BP, variable HP 10–500Hz,
variable LP 40–5,000Hz with 10X switch; 24dB/octave
SUB:
Variable LP 40–160Hz; 24dB/octave
KickEQ™ Parametric Bass Boost
Boost - Variable 0-18db; Center Frequency - 40Hz
Subsonic Filter
Variable 10–80Hz; 24dB/Octave
NOTE: 2017 KXM amplifi er subwoofer channels are 1Ω stable - power rating equivalent to 2Ω operation, +/- 10%
2017 KXM 5ch Amps Rev H.indd 2
2017 KXM 5ch Amps Rev H.indd 2
4/25/2017 1:07:59 PM
4/25/2017 1:07:59 PM
