KLOCK WERKS | VAQUERO KICKER INSTALLATION
3
SPEAKER INSTALLATION
16. Remove the four Phillips head screws, pull the speaker out of its housing and unplug the stock speaker wires.
17. Take the left side speaker wires and insert them through the hole in the bottom of the speaker pod.
(pic 6)
18. Plug the male ends from the amplifier harness into the stock speaker terminals.
(pic 7)
19. Plug the female ends from the amplifier harness onto the Kicker speaker and refasten it to the housing with
the Phillips head screws removed in step 16.
(pic 8)
20. Repeat for the right side speaker.
21. Thread the positive power lead into the protective red cap and fasten to the battery.
(pic 9)
22. Connect the negative power lead and check system operation.
23. Be sure to check that none of the wires will be in a bind when the steering head is turned fully to the right
or the left.
Note:
At this time, it is highly recommended to follow the guidelines in your Kicker PX 100.2 owner’s manual
to set up the amplifier. Klock Werks recommends that the dip switches be set up as follows:
AUTO TURN-ON
- 12V
INPUT LEVEL
- HI
HI-PASS
– OFF
INPUT GAIN CONTROL
– Follow the instructions in your Kicker PX 100.2 owner’s manual Pg. 4
24. Disconnect the negative battery terminal and carefully reassemble motorcycle.
25. Connect negative battery terminal, install the battery cover and seat and enjoy your Kicker audio system!
6
7
8
9
