KLOCK WERKS | VAQUERO KICKER INSTALLATION
2
GETTING STARTED
|
*Please reference model appropriate service manual for procedures and torque specifications.
1. Protect painted surfaces with a soft cloth.
2. Remove the seat.
3. Remove plastic battery cover.
4. Disconnect battery.
AMP INSTALLATION
5. Follow the proper procedure to remove the outer fairing.
6. Install amplifier onto bracket Slide the amplifier into the left side of the bracket and use supplied hardware
to bolt the amp to the bracket.
(Pic 1)
7. Remove the two fasteners holding the radio chassis to the inner fairing bracket
8. Set the amplifier assembly on top of the inner fairing bracket and use the hardware removed in step 7
to fasten it back onto the inner fairing bracket.
(Pic 2)
HARNESS INSTALLATION
9. Follow the proper procedure to remove the fuel tank.
10. Plug harness into the amplifier.
11. Route the right side speaker wires behind the amplifier toward the right side speaker pod.
12. Route the left side wires behind the fairing support toward the left side speaker pod.
(pic 3)
13. The blue wire is to be installed in the accessory power source on the left side of the fairing.
It is a tan wire with a double barrel terminal.
(pic 4)
14. Route the power leads along the main harness.
(pic 5)
:
1. Along the left side of the frame neck.
2. Under the black wire retainer on the neck.
3. Under the front fuel tank bumper.
4. Underneath the anodized wire retainer. (You will have to loosen the bracket)
5. Under the rear fuel tank bumper.
6. Follow the harness down the right side of the frame and under the seat.
15. The blue lead under the seat would be used if installing a second amplifier, but whether used or not,
cover with supplied heat shrink to reduce the risk of a short.
1
2
3
4
5
