Fig. 7
Fig. 5
Fig. 6
Set Screw
Canopy
Download
Motor Coupling
Washer
Set Screw
Fan Assembly
Lcok Pin
Hitch Pin
Cross Pin
Lock Pin
Hanger Ball
Screw
Downrod
Listed electrial
box
Washer
Mounting screw
Mounting bracket
4
Seaside
TM
5. HANGING THE FAN
REMEMBER
to turn off the power before you
begin.
Step 1. Pass the 120 volt supply wires from the ceiling
outlet box through the center of the ceiling mounting
bracket. (Fig. 5)
Step 4. Loosen the two set screws from the
coupling on top of the motor assembly. (Fig. 7)
Step 5. Carefully feed the electrical lead wires from
the fan up through the downrod. Thread the downrod
into the coupling until the hitch pin holes are aligned.
Next, replace the hitch pin and retaining clip.
Tighten both set screws. (Fig. 7)
To properly install your ceiling fan, follow the steps below.
Step 2. Attach the ceiling mounting bracket to the
outlet box using the screws and washers included
with the outlet box. (Fig. 5)
Step 3. Remove the hanger ball from the downrod
assembly by loosening the set screw, removing the
cross pin and sliding the ball off the rod. Remove
the hitch pin and retaining clip from the downrod
assembly. (Fig. 6)
