7
9. ATTACHING THE FAN BLADES
Step 3.
Securely attach and tighten the canopy
hole cover over the shoulder screws in the
mounting bracket utilizing the keyslot twist-lock
feature. (Fig. 15)
NOTE:
Before continuing , make sure the power
is disconnected by turning off the circuit breaker
of removing the fuse at the circuit box.
Step 1.
Position the blade over the blade holder
with three threaded posts showing. Make sure
the bottom edge of the blade is fully seated
against the blade holder. Attach the blade arm to
the blade and blade holder using the three blade
screws. Do not tighten blade screws until all three
have been inserted. Then, tighten each blade
screws securely. Repeat the procedure for all
remaining blades. (Fig.16)
Step 2.
Fasten blade assembly to the holes
located on the bottom of the flywheel. Tighten the
two "pre- installed" motor screws in the blade
arm. Repeat steps for the remaining blades
assemblies. (Fig. 17)
Fig. 15
Fig. 16
Fig. 17
Canopy Hole Cover
Shoulder Screw
Blade
Blade Screw
Blade Arm
Blade Holder
Motor Body
Blade Arm
Flywheel
