2. Detach the air cleaner.
3. Disconnect the connectors for the engine harness.
4. Disconnect the connectors for the alternator harness, the oil pressure switch and the oil pressure sensor.
5. Disconnect the connector of starter motor harness.
6. Drain the engine coolant.
7. Disconnect transaxle oil cooler hose.
8. Disconnect the radiator upper and lower hoses on the engine side, and then remove the radiator assembly.
9. Disconnect the high tension cable and all wires to the distributor and the ignition coil.
10. Disconnect the engine ground.
11. Disconnect the brake booster vacuum hose.
12. Disconnect the EVAP canister hose.
13. Remove the main fuel line, and the return and vapor hoses from the engine side.
14. Disconnect the heater hose (Intake and exhaust) at the engine side.
15. The accelerator cable should be removed from the engine side.
16. The cruise control cable should be removed from the engine side.
17. Remove the control cable from the transaxle.
18. Disconnect the speed sensor connector from the transaxle.
NOTE:
When disconnecting the hoses, make identification marks to avoid making
any mistakes when re-installing them.
CAUTION: Be careful not to spill any of the oil or fluid out of the hoses. Plug the
openings to prevent the entry of foreign material.
CAUTION: To reduce the residual pressure in the hoses, see FUEL PRESSURE
TEST .
2002 Kia Sedona EX
2002 ENGINES 3.5L V6 - Sedona
Helpmelearn
June-06-08 8:54:29 AM
Page 33
© 2005 Mitchell Repair Information Company, LLC.
