Revision Date
4/22/2013
Page 22 of 25
Ignition turns on, burglar horn beeps
two (2) times and vehicle does not
start. Key-In-Sense activated.
Issue / Concern
Items To Be Checked
Instruction Ref.
Step 15
Instruction Ref.
Steps 16 & 20
*Remove ignition key from ignition cylinder.
*Verify that the 6-pin male and female Key-In-Sense
connectors are connected properly (Step 15).
KIA Genuine Accessories
Troubleshooting
*Verify that the Valet Mode is not engaged - Refer
to the Remote Start System Owner’s Guide.
Burglar horn beeps two (2) times and
vehicle does not start. Safety input
activated.
Burglar horn beeps fi ve (5) times and
vehicle does not start. Safety Input
activated.
Instruction Ref.
Step 20
*Close the vehicle’s tailgate.
*Verify that the 26-pin male and female I/P-K
connectors are connected properly (Step 20).
*Release the brake pedal and close the hood.
*Verify that the 4-pin male and female brake switch
connectors at the brake switch are connected prop-
erly (Step 16).
*Verify that the 26-pin male and female I/P-K
connectors are connected properly (Step 20).
Page 6 of
Owner’s Guide
Instruction Ref.
Step 20
Headlights do not turn off thirty
(30) seconds after deactivating the
remote start using the transmitter
(Headlight switch must be in the on
position).
*Verify that the 6-pin male and female ignition switch
connectors at the ignition switch are connected
properly (Step 14).
*Verify the 5-pin relay is engaged properly to the
relay socket on the remote start harness (Wrapped
with large foam tape).
*Verify that the fuses located under the DNA case
top labeled “HVAC1” & “HVAC2” are good and
installed properly per the Fuse and Jumper diagram
in Troubleshooting.
*Verify proper DNA installation into module.
*Verify that the vehicle’s HVAC blower fan is set to
the ON position.
Instruction Ref.
Burglar horn beeps three (3) times
and vehicle does not start. Valet
mode engaged.
*Verify that the 26-pin male and female I/P-K
connectors are connected properly (Step 20).
Instruction Ref.
Step 18
Engine starts, but does not remain
running during remote start
operation.
*Verify that the remote start harness wire (Alternator)
was connected properly to the correct vehicle wire
(Step 18).
Note:
Ensure that the Alternator T-Tap and spade
terminal are properly connected.
Refer to
Page 3 for T-Tap Installation Procedure.
Instruction Ref.
Step 14
Vehicle’s air conditioning / heater
blower fan does not operate during
the remote start mode.
