5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model HF
Assembly Instructions
Electrical Cables
Note:
Control cables can be
routed differently than shown. Your
configuration may vary.
Note:
The wire trough is an
accessory that may be ordered
separately. Your configuration may
vary.
1. Connect the extension cables to the
leg cables, then connect cables to the
M1 and M2 sockets on the control
box (Figure 6).
Note:
Be sure the keypad cable end
is properly aligned before pushing it
into the socket
(Detail D).
2. Connect the keypad cable to the HS
socket on the control box (Figure 6).
3. Using the “P” shaped cable clamps
and #10 x
3
/
4
” self-drilling screws
provided, secure the column and
keypad cables to the worksurface. Be
sure to position a cable clamp within
8” of where the cable connectors
plug into the control box (Detail E).
Note:
No cable clamps are required
for the power cord.
tabletop
control
box
Figure 6
power
cord
extension
cables
column
cable
keypad
cable
cable
clamp
Detail D - Keypad Cable End
alignment feature
Detail E - Cable Clamp
#10 x /
screw
3
4
”
cable
clamp
Detail F
grounding
pin
grounded
outlet
This product is for use on a nominal 120-volt circuit and has a grounding plug
that looks like the plug illustrated in Detail F. Make sure that the product is
connected to an outlet having the same configuration as the plug. No adapter
should be used with this product.
GROUNDING INSTRUCTIONS
