U-Series
®
Pedestal - Panel Supporting Bracket
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
3
#10-16 x /
1
2
"
self-drilling
sheet metal screw
panel supporting
bracket
1
/ -20 KEPS nuts
4
spacer attachment
(right-hand shown)
pedestal
Figure 4
Figure 5
panel supporting bracket
(left-hand installed)
U-Series
®
Pedestal - Panel Supporting Bracket
Assembly Instructions
U-Series Pedestal, Panel
Supporting Bracket with Spacer
1. Locate the spacer attachment
along the top and side edge of the
pedestal as shown (Figure 4).
Note:
For right-hand
installations, align the spacer with
the right side of the cabinet with
the studs facing left (Figure 4).
For left-hand installations flip the
spacer over and align the bracket
on the left side of the cabinet with
the studs pointed right (Figure 5).
Important:
Care should be
taken to ensure that the spacer
is aligned well with the top and
side of the cabinet for cosmetic
integrity and safe installation of
the worksurfaces. Using a small
piece of double-sided tape at the
top and bottom of the bracket
to hold it in place can aid in
alignment of the spacer.
2. Using the four #10-16 x
1
/
2
”
self-drilling sheet metal screws
provided, carefully secure the
spacer to the cabinet (Figure 4).
3. Attach the panel supporting
bracket to the spacer. Secure to
the threaded studs on the spacer
with the four ¼-20 KEPS nuts
provided (Figure 4).
4. To install pedestal to worksurface,
go now to page 4.
Tip:
A small piece of double-sided tape
will help hold the bracket in alignment to
the pedestal while driving the self-drilling
and tapping screws into place.
