2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
U-Series
®
Pedestal - Panel Supporting Bracket
Assembly Instructions
U-Series Pedestal, Panel
Supporting Bracket without
Spacer
1. Position the panel supporting
bracket along the top and side edge
of the pedestal as shown. Be sure
the teeth are facing up (Figure 2).
Note:
If a spacer-type panel
supporting bracket is required, go
to page 3.
Important:
Care should be taken
to ensure that the supporting
bracket is aligned well with the top
and side of the cabinet for cosmetic
integrity and safe installation of the
worksurfaces. Using a small piece
of double-sided tape at the top and
bottom of the bracket to hold it in
place can aid in alignment of the
supporting bracket.
2. Using the four #10-16 x
1
/
2
”
self-drilling sheet metal screws
provided, carefully secure the panel
supporting bracket to the cabinet
(Figure 2 or 3).
Note:
For right-hand installations,
align the supporting bracket with
the right side of the cabinet
(Figure 2). For left-hand
installations align the supporting
bracket with the left side of the
cabinet (Figure 3).
3. To install pedestal to worksurface,
go now to page 4.
Tip:
A small piece of double-sided tape
will help hold the bracket in alignment to
the pedestal while driving the self-drilling
and tapping screws into place.
Figure 3
panel supporting bracket
(left-hand installed)
Figure 2
panel supporting bracket
(right-hand shown)
#10-16 x /
1
2
"
self-drilling
sheet metal screws
