3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Soltice
®
Metal Multiple Seating - Reconfiguring Multiple Seating
Repair & Replacement Instructions
Note:
The left- and right-hand side
of each seating unit is determined
when the user is facing the front of
the unit as illustrated in Detail A.
To identify the correct placement
of left- or right-handed connecting
table brackets on each side of the
seating unit, reference Details A, B
& C on page 2.
Note:
Do not completely remove
the seat mounting screws, as
this will make the chair unstable
and very difficult to reassemble
properly. Do not loosen both
sides of the seat at the same time.
Assemble one table bracket at a
time.
8. Using a Phillips screwdriver,
loosen the front and back seat
screws which hold the seat bottom
to the frame. Twist the seat screws
counter-clockwise, only two full
rotations (Figure 4 & Detail E).
9. Center the connecting table bracket
between the seat screw mounting
tabs and push in tightly against
the arm stringer rail (Figure 4 &
Detail E).
10. Tighten the seat screws which
were loosened in step 8. Secure
the connecting table bracket to the
bottom of the seating unit using
the four #10 x
3
/
4
” wood screws
removed in step 5 (Figure 4).
11. Repeat steps 8 through 10 to install
the remaining connector table
brackets.
12. Carefully turn all seating units to
the upright position.
Caution:
the assistance of a second person
is required to turn seating units
upright that exceed three seating
positions.
Figure 4
connecting
table bracket
(right hand shown)
#10 x / ”
Phillips wood
screws
3
4
seat
screw
seat
screw
connecting
table bracket
(right hand shown)
arm
stringer rail
seat
screw
Detail E
#10 x / ”
Phillips wood
screws
3
4
