3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Pirouette Tables™ Nesting-Base with Villa, PowerUp or No Power - Nesting Legs to Tabletop
Assembly Instructions
Figure 4
beam head
cover
beam head
cover
paddle
nesting bumper
(face user side)
nesting table
support beam
#8-32 x / ”
1
2
thread forming
screw
#8-32 x / ”
1
2
thread forming
screw
#8-32 x / ”
1
2
thread forming
screw
Figure 5
glide
caster
(locking)
caster
(non-locking)
Nesting Legs to Tabletop
Installation (cont.)
4. Beam head covers are right- and
left-handed, so identify which
cover mates at each base/beam
location. Insert cover into place by
first inserting the inward facing tab
into the slot at the underside of the
nesting table beam support, then
rotate the beam head cover down and
align the two tabs with the mounting
holes in the base. Repeat the process
for the cover on the other base end.
At the side of the base opposite the
user side, using a cordless drill with
a #2 Phillips bit insert and tighten
a #8-32 x
1
/
2
” thread forming screw
through the base and into the tab of
each beam head cover as illustrated.
Next, locate two nesting bumpers
and place a #8-32 x
1
/
2
” screw
through each bumper, then insert and
tighten the screw into the user side
mounting hole, through the base and
into the mounting hole in the tab in
the beam head cover on both ends
of the base as illustrated (Figure 4 &
Detail B).
Important:
For proper storing
and nesting of tables,
the nesting
bumpers must be installed to
the user side
, the side of the base
with the paddles.
5. Locking and non-locking casters
are provided. Locking casters are to
be installed to the front, user side
of each leg and non-locking casters
should be installed to the rear of
each leg. Use a
3
/
4
” open end wrench
to tighten casters to the foot of each
leg (Figure 5).
6. To attach glides, thread stem into
bottom of leg by hand (Figure 5).
Detail B
nesting bumper
(face user side)
#8-32 x / ”
1
2
thread forming
screw
nesting leg
(right)
#8-32 x / ”
1
2
thread forming
screw
Note:
Nesting bumper must be assembled to
the user side for table to function properly.
