5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Doni
™
, Strive
®
,
Grazie
®
& Tandem Seating
Assembly Instructions
assembled corner table unit. It is
recommended to assemble corner
table to tandem units at or near
their final installation location
(Figure 3).
13. At the locations where the corner
table beams will attach to the
tandem seating unit (either directly
under a yoke plate of a D-base or
yoke plate of an arm), remove the
two outermost bolts of both units
at the installation locations as
illustrated (Figure 3).
14. Carefully turn the corner table
assembly to the upright position
and move it into position for
installation. With two or more
people, hold the corner table in
place and align the mounting
holes of the two beam joint bottom
brackets with the mounting holes
in the yoke plate of an arm, or yoke
plate of a D-base leg (where bolts
were removed in step 13). The
corner table beams may need to be
adjusted in or out as required (bolts
left loose in step 11) to properly
space the corner table to either an
arm or a seat on a tandem seating
unit (Figure 3).
15. At the underside of each of the two
beam joint bottom brackets, insert
the two
5
/
16
-18 x 1” hex head bolts
and lock washers as illustrated, up
through the yoke plate and into the
yoke under a seat or an arm. Torque
bolts to 21 ft/lb, taking care to not
over-tighten.
16. Once the corner table beams are
securely attached to the beams of
the tandem seating units, the corner
table beam lengths can be
fine-tuned under the corner table,
then the four bolts (from step 11)
must be tightened, securing the
corner table beams to the corner
table frame (Figure 3).
17. Finally, adjust the glide in the
corner table leg either in or out to
level the surface.
Note:
Depending on the tandem
seating configuration specified,
the corner table beam joint bottom
brackets may install to either the
underside of a yoke plate at a seat,
or to a yoke plate of an arm.
12. Arrange the two tandem seating
units at 90° to each other with
space enough to receive the
Figure 3
5
/ -18 x 1”
hex head
bolt &
lock washer
16
beam joint
bottom bracket
beam joint
top bracket
D-Base
D-Base
beam joint
top bracket
yoke
plate
Strive seat
assembly
Torsion seat
assembly
corner
table
arm
assembly
yoke
beam joint
bottom bracket
yoke
plate
5
/ -18 x 1”
hex head
bolt &
lock washer
16
corner table
leg glide
