1. Drill
1
/
2
" (13mm) hole. Hold metal
channel flat alongside plastic strap
and slide channel through hole
(Figure 3). Minimum clearance
behind wall should be 1
7
/
8
"
(48mm).
2. Hold end of straps between thumb
and forefingers and pull toward
you until channel rests flush
behind wall. Slide plastic cap
along strap with other hand until
flange of cap is flush with wall.
Note:
Do not stress or pull legs at
an angle to avoid premature
breakoff.
3. Snap straps at wall by pushing
side-to-side, snapping off straps
level with flange of cap.
4. Place item to be attached to wall
over flange. Insert bolt through
item and tighten until flush against
item, then stop. Use machine
screw or bolt to match thread
channel: bb
1
/
2
" (20mm).
IMPORTANT:
The plastic legs and cap
washers are positioning and position
retention elements only. They do not
otherwise function as anchoring
elements. Holding is dependent only
on a metal bolt to metal channel
connection. The TOGGLERS
®
brand
toggle bolt anchor complies with all
existing fire codes for critical
applications.
Assemble units as described herein only. To do otherwise may
result in instability. All screws, nuts and bolts must be tight-
ened securely and must be checked periodically after assem-
bly. Failure to assemble properly, or to secure parts may result
in assembly failure and injury.
Aristotle Casegoods™ Wall-Mounted Overhead Cabinet
SNAPTOGGLE
®
Toggle Bolts BB (
1
/
2
"
-20) Instructions
3
Figure 1
Figure 2
Figure 3
Figure 4
