Note:
These instructions are for
attachment to conventional stud and
wallboard structures only, using the
Toggle Bolt Anchors supplied in the
hardware pack 7HP21.
Important:
Refer to the “Required
Hardware” chart below for the minimum
number of bolts, and for the minimum
number of wall stud anchorages
required to support each size of
overhead. Always use more than the
minimum number of wall stud
anchorages if possible.
1. Carefully unpack all parts and place
overhead cabinet onto a soft,
protective surface. Identify parts
below from the “Hardware Packs”
diagram & Figure 1.
2. Remove lower mounting cleat from
rear of the overhead (Figure 1).
Retain shipping screws for further
use.
Assembly Instructions
Aristotle™ Casegoods
Wa l l - M o u n t e d O v e r h e a d C a b i n e t
March 2008
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
1330 Bellevue Street • P. O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2008 KI All Rights Reserved • Litho in USA • Code KI-62012/HT/PDF/0308
Hardware Packs
Toggle
Bolt
#10 x 3”
Wood Stud
Screw
Toggle
Bolt Anchor
10
10
4
4
15
15
7HP21
- A
- B
uppe
r
mounting
c
leat
lowe
r
mounting
c
leat
ove
r
head
c
abinet
Figure 1
Overhead width
30"
36"
42"
48"
54"
60"
66"
72"
78"
Wall stud anchorages
required (minimum)
Mounting bolts
required (minimum)
Allowable load
(maximum - lbs.)
Hardware Pack
77H
HP
P2211--A
A
77H
HP
P2211--B
B
Required Hardware
1
1
1
2
2
2
2
2
3
7
8
9
10
12
13
14
15
15
300
360
420
480
540
600
660
720
780
