Assembly Instructions
All Terrain
®
Panel Rail
July 2012
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
AT-TLRail-Pnl
Assembly Instructions
All Terrain Panel R ail
Note:
The following instructions
refer to the installation of an All
Terrain Panel Rail to panel/wall
system using WireWorks panel-
mount brackets. Different brackets
may be used, depending on type
of panel/walls. Panel rails can be
mounted "off-module", so rail may
be longer than the width of the
wall panel to which it’s installed.
1. Orient the panel rail with the
tapered edge down and the hook
end up, as illustrated (Detail A).
2. Determine which panel-mount
brackets are right- and left-hand
and position accordingly (Figure
1). Slide brackets into the panel
rail extrusion ends and align the
bracket hooks with the width of
the slotting pattern in panel walls.
Ensure that the panel rail is level
and slide the top hooks of the
brackets into wall slots at the
desired height. Rotate lower
hooks into slots and press down
to secure (Figure 2).
panel rail
(side view)
tapered
edge
hook
edge
(top)
36" wide
panel
48" wide
panel rail
panel-mount
bracket
(left-hand)
panel-mount
bracket
(right-hand)
panel rail
extrusion
Figure 1
Figure 2
Detail A
1330 Bellevue Street • P.O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2012 KI All Rights Reserved • Litho in USA • Code KI-61508R1/KI/PDF/0712
Note:
The following instructions refer
to the installation of an All Terrain
Panel Rail to panel/wall system
using WireWorks
®
panel-mount
brackets. Different brackets may be
used, depending on type of panel/
walls. Panel rails can be mounted
“off-module”, so rail may be longer
than the width of the wall panel to
which it’s installed.
1. Orient the panel rail with the tapered
edge down and the hook end up, as
illustrated (Detail A).
2. Determine which panel-mount
brackets are right- and left-hand and
position accordingly (Figure 1). Slide
brackets into the panel rail extrusion
ends and align the bracket hooks with
the width of the slotting pattern in
panel walls. Ensure that the panel rail
is level and slide the top hooks of the
brackets into wall slots at the desired
height. Rotate lower hooks into slots
and press down to secure (Figure 2).
Part #80500
