Ki Mobility ROGUE XP, User Instruction Manual & Warranty

Page: 29 / 76

28
IV. WHEELCHAIR USE & CONFIGURATION
Q. Seat Upholstery (Continued)
How to Replace Seat Upholstery
1. Remove the 5mm Phillips head screws (Fig. 15) from the seat rails on each side of the frame
and set aside.
2. Remove the seat upholstery from the seat rails.
3. Slide the new seat upholstery onto the seat rails.
4. Line up the holes in the seat rails with the threaded inserts in the frame.
5. Replace the 5mm Phillips head screws (Fig. 15) by partially threading into place. Once all
screws have been started, go back and tighten to secure.
R. Standard 5th Wheel
If the Standard 5th Wheel caster touches the ground, it is possible that the large rear wheels
might not touch the ground. Adjust the height of the caster to prevent the rear wheels from not
touching the ground and consider a higher position if being used outdoors or on uneven
surfaces.
How to Insert and Remove the Standard 5th Wheel
1. Press the two release buttons (Fig. 16:A) on the support tube so that both buttons are drawn
inside.
2. Insert the assembly into the support tube receiver (Fig. 16:B).
3. Rotate the support tube down until the release pin buttons are positioned through the
receiver mounting holes.
4. Remove by pressing the two release buttons (Fig. 16:A) on the support tube and pulling out
of the support tube receiver.
How to Adjust the Position from the Floor
1. Remove the wing nut (Fig. 16:C) from the bolt holding the caster housing into the support
tube.
2. Slide the housing to the desired height and replace the bolt and secure the wing nut.
A
B
C
Fig. 16